Remover - Hanafy Pigment - 15ml - Non Reach

Remover No. 1 HANAFY

Composition : magnesium oxide, zinc oxide, water, glycerin, isopropanol.

Description :
Mineral remover with an alkaline pH (7.7). Opaque white liquid requiring careful mixing and stirring before use (the use of a pigment stirrer is recommended).
In case of excessive thickening, dilution is permitted using Hanafy Diluent.

Instructions :
You should work with a 3 RL needle, in short, dense strokes, passing evenly over all the areas needed for removal.
For best results, make two full passes over the entire area to be removed.
Only preliminary anesthesia is used; secondary anesthesia is not used during labor.
After each pass, leave the remover on the skin for 3 to 5 minutes, then gently wipe off with chlorhexidine.
After the second pass, you can use a salt activator to enhance the result - either by applying it as a mask to the treated area for 5 minutes, or by diluting the remover 1 to 1 and performing the third pass with lighter movements, as when spraying permanent makeup.

Post-procedure care:
1 day - do not touch.
From the second day, lubricate twice a day with Bepanten or Depanthenol.
Other restrictions are the same as for PM (do not soak, do not spray, do not tan, do not subject to mechanical damage).
Repeat procedure - at the earliest after 6 weeks.